Pioneer PDA-5003 Connection of composite SYNC analog RGB source, Connections for PDA-5004

English

Installation and Connections

When connecting to COMPONENT VIDEO (INPUT5)		When connecting to ANALOG RGB (INPUT5)
[Connections for PDA-5004]		[Connections for PDA-5003]
COMPONENT	INPUT5	ANALOG RGB	INPUT5
VIDEO
		G(ON SYNC) BR	HD (H/V SYNC) VD
Y Pb/Cb Pr/Cr

Installation and Connections

On-screen setup is necessary after connection. Please see pages 18 to 20.

Connection of composite SYNC analog RGB

source

Make composite SYNC connections for a personal computer with output that has the vertical synchronization signal layered on top of the horizontal synchronization signal.

When connecting to ANALOG RGB IN (INPUT1)

ANALOG RGB IN	ANALOG RGB OUT	INPUT1
D-Sub	D-Sub	AUDIO

On-screen setup is necessary after connection. Please see pages 18 to 20.

When using INPUT5, set the impedance selector switch to match the output impedance of the connected computer’s synchronization signal.

When the output impedance of the sync signal is below 75 Ω remove the video card and set the impedance selector switch to 75 Ω (page 6).

On-screen setup is necessary after connection. Please see pages 18 to 20.

Notes

÷When making composite SYNC connections, do not connect anything to the VD jack. If connected to, the picture may not be displayed properly.

÷Some types of computer devices manufactured by Apple Computer, Inc. are equipped with both G ON SYNC and composite SYNC outputs. This type of component should be connected using the G ON SYNC connection (page 11).

12

En