Pioneer PDA-5003, PDA-5004 manual Connection to INPUT2, Connection to INPUT4, Connection to INPUT3

Installation and Connections

Connection to INPUT2

A computer equipped with DVI output (digital RGB signal) can be connected to the plasma display’s DVI connector.

	INPUT2
DIGITAL RGB	AUDIO
DVI-D

Connection to INPUT4

Connect an AV component that has a video output jack to the video card’s INPUT4 jack. The VIDEO OUT (INPUT4) jack can be used to output the video signal to a separate monitor, recording device or other component with video input capability.

Note

English

Personal computer

On-screen setup is necessary after connection. Please see pages 18 to 20.

Notes

¶Use a DVI-D 24-pin (digital only) cable for the connection.

¶This unit does not support the display of copyguard- protected video signals.

NOTICE

¶INPUT2 is compatible with Microsoft’s Plug & Play (VESA DDC 2B).

¶For the screen sizes and input signals that INPUT2 is compatible with, please refer to the plasma display’s Operating Instructions.

Connection to INPUT3

Connect an AV component that has S-video output jack to the video card’s S-VIDEO (INPUT3) jack.

S-VIDEO INPUT3

AV component

A video signal will not be output from the VIDEO OUT (INPUT4) jack when the main power of this display is off or in standby mode.

[When using PDA-5003]

VIDEOINPUT4

IN OUT

To a monitor or a recording device

AV component

[When using PDA-5004]

VIDEOINPUT4

IN OUT

To a monitor or a recording device

AV component

Signals to the INPUT3 and INPUT4 jacks are all compatible with the following TV systems: NTSC, PAL, SECAM, 4.43NTSC, PAL M and PAL N. For details, please refer to “Setting the COLOR SYSTEM” on page 39.

Installation and Connections

13

En