The images, video clips, and audio recordings you take are stored on the card installed in the digital camera. If a card is not loaded into the digital camera or if the card is full, capturing or playing back images will not be possible. Make sure to check the status of the card in the digital camera before capturing images. For an indication of how many images can be captured and how much recording time is available for your card, see “Possible No. of Images/Possible Shooting Time/Possible Recording Time” on page 129.
Checking the Remaining Number of Images and Video Recording Time1
2
œ Set the selector dial to anything other than P. œ The remaining number of images appears in the upper right of the LCD monitor (for the still image
and sequential shot shooting modes).
œ The remaining video recording time appears in the top of the LCD monitor and the remaining number of video clips appears in the upper right of the LCD monitor (for the video clip shooting mode).
œ The remaining number of images and video recording time will differ depending on the resolution and compression settings.
œ When the remaining number of images or video clips that can be taken is “0”, you cannot capture any more images. To capture more images, either install a new card, or save the current images (see page 48) and then erase them (see page 106) from the card.
œ When the remaining number of images or video clips that can be taken is “0”, it may be possible to capture a few more images by changing the shooting mode, setting a lower resolution setting (see page 51), or selecting a different compression setting (see page 53).
PLAY 
CAMERA
MONITOR OFF
Main switch
Selector dial
19
Remaining number of images possible (Still image shooting screen)
Remaining video recording time (min:sec)
00:24
1
Remaining number of video clips possible (Video clip shooting screen)
English 46