Sanyo CL1852 Power Supply Wires, Measurement of Insulation Re- sistance for Electrical parts

11. SERVICE PROCEDURES

(4)Checking the Electrical Components

1)Measurement of Insulation Resistance

•The electrical insulation is acceptable when the resistance exceeds 1 MΩ.

1Power Supply Wires

Clamp the earthed wire of the Power Supply wires with a lead clip of the insulation resistance tester and mea- sure the resistance by placing a probe on either of the power wires. (Fig. 13)

Then measure the resistance between the earthed wire and the other power wires. (Fig. 13)

2Indoor Unit

Clamp an aluminum plate fin or copper tube with the lead clip of the insulation resistance tester and measure the resistance by placing a probe on the terminal plate (Fig. 14)

3Outdoor Unit

Measure the resistance by placing a probe on the terminal plate in the same manner as explained above 2. (Fig. 14)

4Measurement of Insulation Re- sistance for Electrical parts

•Disconnect the connector of the desired electric part from terminal plate, P.C.B. Ass’y, etc. (Fig. 15)

•Similarly, disconnect the lead wires from compressor, capacitor, etc. (Fig. 16)

•Measure the resistance in the same manner as illustrated on the right.

Refer to Electrical Wiring Diagram.

NOTE

If the probe does not enter the hole because the hole is too narrow, use a probe with a thinner pin.

Earthed wire

Clip

Probe

Insulation tester

0638_X_S

Terminal plate

Probe

Clip
Copper	Insulation
tube or	tester
metallic part

0639_X_S

Probe

Clip

Copper tube or metallic part

Insulation tester

0640_X_S

From fan motor, compressor and other parts.

Metallic	Probe
part
Clip

Insulation tester

0641_X_S

Fig. 13

Fig. 14

Fig. 15

Fig. 16

SM830079

– 41 –