CX200 User's Guide
4.If you have been printing many labels, the printer may have overheated. Normal operation will resume after the printer has cooled sufficiently.
Self-test label will not print
1.If printing in the direct thermal mode, confirm that you have loaded di- rect thermal media.
2.Disconnect the cable between the printer and the host computer. Reset the printer as described on page 10. Then try to print a
Labels will not feed
1.Confirm that the print media is loaded correctly.
2.Reset the printer as described on page 10. Confirm that the printer LED indicator glows green. Press the FEED button.
3.If the printer still does not feed, disconnect the communications cable and repeat step 2. If the printer feeds with the cable disconnected, sus- pect a problem with the host computer or cable.
Host stops responding or displays “printer not ready” message
1.Review your software setup, following the instructions provided with the software.
2.Confirm that the
3.If using the serial port, confirm that the host and printer are both using the same serial port parameters. The
4.If using a communications switch between the host and printer, remove the switch and connect the printer directly to the host.
5.Reset the printer as described on page 10, reset the host computer and software, and try printing again.
PN 9001050 Rev. B | Page 13 |
