Scag Power Equipment GC-STC manual A, Back Side Idler Pulley Blower Pulley, Front Side

9.Install the belt to the spindle pulley. When replacing the belt, see figure below.

BACK SIDE

IDLER PULLEY BLOWER

PULLEY

FRONT SIDE	SPINDLE
	PULLEY
IDLER PULLEY

10.Install the new belt covers and secure. See items number 1 and number 21 on page 9 of the Blower Mounting Components secton in the Illustrated Parts List for proper installation.

11.Install the hopper mounting brackets to the outside of the frame on the rear of the machine.

See Figure 4.

Hopper

Mounting

Brackets

Rear Frame

Figure 4 A GC-STT Install Art

Figure 4

12.Attach the hood assembly to the machine by installing the mounting post into the hopper mounting brackets and secure with the ring pins.

See Figure 5.

Figure 5

13.Install the hose from the blower assembly adapter to the hopper hood and secure using the 6-1/2" clamps.

14.Install the bag assemblies.

15.Using the weight support bar as a guide, identify the four corresponding mounting holes, and the existing hardware that will need to be removed in order to secure the weight support bar to the front of the machine as shown. See Figure 5-A.

16.Install one 7/16-14 x 1-3/4" hex head bolt into each of the four mounting holes in the weight support bar, and through the matching holes in the caster support weldment. Secure this assembly to the front of the machine using the 7/16- .5" x 1-1/4" x .083" flatwashers, and the 7/16-14 elastic stop nuts. Torque hardware to 59 ft. lbs. See Figure 5-A.

Figure 5-A

17. Operate and test.

4