Scag Power Equipment GC-STC manual Grass Catcher Removal Instructions

4.1GRASS CATCHER REMOVAL INSTRUCTIONS

1.Prepare the work area making sure that it is a clean, safe environment.

2.Remove the bag assemblies from the grass catcher.

3.Remove the rubber strap holding the adapter to the blower assembly. See Figure 6.

4.Remove the pin holding the blower assembly to the mounting bracket on the cutter deck and remove the blower assembly. See Figure 6.

		ADAPTER
BLOWER		MOUNTING
ASSEMBLY
	PIN	BRACKET

RIGHT SIDE OF

CUTTER DECK SHOWN

(Note: Some parts not shown for viewing purposes.)

GC-STC removal art 1

Figure 6

5.Remove the two (2) pins holding the hood assembly to the mounting posts on the rear of the machine. See Figure 7.

REMOVE

MOUNTING

PINS

GC-STC removal art 2-A

Figure 7

6. Remove the hood assembly.

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING

KIT, OR ENTIRE GRASS CATCHER INSTALLED

7.Re-install the side discharge chute to the opening on the cutter deck. Replace the two outside mounting bolts on the discharge chute with the clevis pins (p/n 04064-15) and rue cotter pins (p/n 04069-03). See Figure 8.

DISCHARGE	CLEVIS PIN
CHUTE	P/N 04064-15

CLEVIS PIN
P/N 04064-15	RUE COTTER PIN
	P/N 04069-03
	GC-STC removal art 3

Figure 8

5