6.Hourmeter (Figure 4-1). Indicates the number of hours the engine has been operated. It operates whenever the engine is running. Has preset maintenance reminders for engine and hydraulic system oil changes. Will start flashing scheduled maintenance 2 hours before preset time and continue flashing until 2 hours after. Automatically resets.
7.Fuse Holders (Figure 4-1). Two 20-amp fuses protect the mower’s electrical system. To replace fuses, pull fuse out of the socket and install a new fuse.
8.Left Steering Control (Figure 4-1). Used to control the mower's left wheel when traveling forward or reverse.
9.Right Steering Control (Figure 4-1). Used to control the mower's right wheel when traveling forward or reverse.
10.Parking Brake Control (Figure 4-1). Used to engage and disengage the parking brakes. Pull the lever back to engage the parking brakes. Push the lever forward to disengage the parking brakes.
11.Dump Valve Control Levers (Figure 4-2). Located on the left and right side of the bumper, used to “free-wheel” the mower. Rotating the levers forward into the notch (towards the front of the mower) allows the unit to move under hydraulic power. Rotating the levers backward to the notch (towards the rear of the mower) allows the mower to be moved by hand (free-wheeling).
DUMP VALVE
CONTROL LEVER
"DRIVE" POSITION
"FREEWHEEL" POSITION
2007 SFZ DVL
Figure 4-2. Dump Valve Control
12.Deck Lift Foot Lever (Figure 4-1). Used to raise and lower the cutter deck.
13.Cutting Height Adjustment (Figure 4-1). Used to set the cutter deck at the desired cutting height.
14.Deck Release Lever (Figure 4-1). Used to lock the cutter deck in the transport position. Push the foot pedal forward and pull back on the release lever to release the cutter deck for normal mowing.
15.Seat Belt (Figure 4-1).Used to secure the operator. Seat belt must be worn at all times during operation.
16.Seat Hold Down Release Latch (Figure 4-1). Located behind the seat. Used to secure the seat in the operator's position. Release the latch to gain access under the seat.
4.2 SAFETY INTERLOCK SYSTEM
The mower is equipped with a safety interlock system that prevents the engine from starting unless the deck drive is disengaged, the steering control levers are in the neutral position and the operator is in the seat. The interlock system shuts off the engine if the operator leaves the seat with the steering control levers not in the neutral position and/or the cutter blades engaged and the parking brake not engaged.
WARNING
Never operate the mower with the interlock system disconnected or malfunctioning. Do not disengage or bypass any switch; injury to yourself and others or property damage could result.
4.3 INITIAL RUN-IN PROCEDURES
First Day of Use or Approximately 20 Hours
1.Check all belts for proper alignment and wear at 2, 4 and 8 hours.
2.Change the engine oil and oil filter after the first 20 hours of operation. (See Section 7.4.)
3.Check hydraulic oil level in reservoir. (See Section 7.3.)
4.Check for loose hardware. Tighten as needed.
