Scag Power Equipment STWC48V-26KA-LC Body, Deck, And Upholstery, Section, 9. Debris Screen

R

Section 7

3.Replace the radiator cap. Push down on the cap and turn clockwise until it stops.

- NOTE -

The cooling system should be flushed and the coolant replaced every 500 hours of operation or annually. See your Scag dealer for proper coolant replacement.

B. Cleaning the Radiator Debris Screen

After each day of operation, remove and clean the radiator debris screen.

Caution

To avoid personal injury, always wear safety glasses when using compressed air.

1.Release the debris screen latch and pull the debris screen towards the latch to remove. See Figure 7-9.

DEBRIS SCREEN

LATCH

3.Re-install the debris screen to the radiator and secure with the latch.

7.12 Body, Deck, And Upholstery

Caution

Do not wash any portion of the equipment while it is hot. Do not wash the engine; use compressed air.

1.After each use, wash the mower and cutter deck. Use cold water and automotive cleaners. Do not use pressure cleaners.

2.Do not spray electrical components.

3.Use a mild soap solution or a vinyl/rubber cleaner to clean the seat.

4.Repair damaged metal surfaces using Scag touch- up paint available from your authorized Scag dealer. Wax the mower for maximum paint protection.

Figure 7-9. Debris Screen

2.Clean the debris screen with compressed air or a water hose.

- NOTE -

Check the radiator for excessive debris and clean with compressed air. Never spray a hot engine with water, use only compressed air to remove debris.

38