Cleaning and care, Cleaning the coarse filter | Miele G 7783 CD

Cleaning and care

Cleaning the filters in the water cabinet

The filter combination in the base of the cabinet should be inspected regularly and cleaned if necessary.

Caution!

Watch out for glass splinters which could cause injury.

Cleaning the coarse filter

Press the 2 lugs together, remove and clean the filter.

Put the clean filter back in position and press until it clicks in place.

Cleaning the fine, flat and micro-fine filters

Remove the coarse filter

Remove the fine filter (if fitted) from between the flat and micro-fine filters.

To unscrew the micro-fine filter, take hold of the two lugs, turn twice in an anti-clockwise direction.

Remove, together with the flat filter. Clean the filters.

The filter combination is then re- placed in the reverse order to which it was removed.

The machine must not be used without all the filters in place.

31

Image 35

Miele G 7783 CD Cleaning and care, Cleaning the filters in the water cabinet, Cleaning the coarse filter

Contents

CD Mielabor Contents Guide to the machine 10 11 12 13 Correct usage Page Page Disposal of an old machine Accessories Available at extra cost Description of the machine Setting the WaterSoftener Setting the water softener Reactivating the water softener, see To close the door Opening and closing the doorTo open the door a Removing excess soils Applications and loadingLoading the machine Loading example 106 Top basket frame can take various inserts109 To adjust the top basket Adjusting the top basket Refilling with rinsing agent Setting the dosageRinsing agent Adding Rinsing agent Adding detergents Adding neutralising agent and liquid detergentAdding neutralising agent Checking the dispensing system Venting the liquid dispensing system / MaintenanceVenting the liquid dispensing system Adding powder detergent Programme selection Programme B, and when using O-175 or a pipette plateAdding detergent = Cold Programme chart Instructions for the operator 7783 CDPage Page Accessories 93C 70C Programme Changes Switching the machine on and offSelecting a programme Selecting an additional pro- gramme Switching the machine on and off Interrupting a programme Programme sequence indicatorSwitching off 1c. AD water connection 1a. Cold water connection1b. Hot water connection Programming special functions Filling the salt container Reactivating the water softener Position the salt container as follows Switch on the machine Cleaning the fine, flat and micro-fine filters Cleaning and careCleaning the filters in the water cabinet Cleaning the coarse filter Cleaning the filters in the water inlet Exchanging the S-class particle filter Drying unit TA cleaning and careChanging the Coarse Filter Machine does not start Correcting minor faultsFaults/Possible Causes Position and secure the machine InstallationImportant for machines with DHK steam condensor Cover plate worktop protection Electrical connection To remove service panel and cover plate Electrical connection Connection to the water inlet Plumbing Connection to purified water non- pressurised 0 1.5 bar AD connection to purified water, pressurised, 1.5 10 bar Ventilation of the wash cabinet at rear Drainage Disposal of your old machine Caring for the environmentDisposal of the packing material Noise emission in dB a Technical Data