Electrical connection | Miele G 7783 CD instruction

Electrical connection

All electrical connection work must be carried out by a qualified electrician in compliance with local and national regulations.

Connection should be made via a suitable isolator, with an on-off switch which should be easily accessible for servicing.

For extra safety it is advisable to in- stall a residual current device (RCD) with a trip current of 30 mA (DIN VDE 0664).

WARNING

THIS APPLIANCE MUST BE

EARTHED

For technical data see data plate or wiring diagram supplied.

The machine must only be operated with the voltage, frequency and fusing shown on the data plate.

The machine is not convertible.

The wiring diagram is to be found be- hind the cover plate on the left hand side, attached to the floor of the ma- chine.

The data plate with test certification is on the rear of the machine, and on the cover plate (behind the service panel).

To remove service panel and cover plate

Holding the service panel at the top right and bottom left hand corners, pull up out of its retainers and lift out at the bottom.

Isolate the machine from the power supply.

Unscrew the cover plate.

Pull off earth lead if necessary.

37

Image 41

Miele G 7783 CD operating instructions Electrical connection, To remove service panel and cover plate

Contents

CD Mielabor Contents Guide to the machine 10 11 12 13 Correct usage Page Page Disposal of an old machine Accessories Available at extra cost Description of the machine Setting the WaterSoftener Setting the water softener Reactivating the water softener, see To close the door Opening and closing the doorTo open the door a Removing excess soils Applications and loadingLoading the machine Loading example 106 Top basket frame can take various inserts109 To adjust the top basket Adjusting the top basket Rinsing agent Setting the dosageAdding Rinsing agent Refilling with rinsing agent Adding detergents Adding neutralising agent and liquid detergentAdding neutralising agent Checking the dispensing system Venting the liquid dispensing system / MaintenanceVenting the liquid dispensing system Adding powder detergent Programme selection Programme B, and when using O-175 or a pipette plateAdding detergent = Cold Programme chart Instructions for the operator 7783 CDPage Page Accessories 93C 70C Selecting a programme Switching the machine on and offSelecting an additional pro- gramme Programme Changes Switching the machine on and off Interrupting a programme Programme sequence indicatorSwitching off 1c. AD water connection 1a. Cold water connection1b. Hot water connection Programming special functions Filling the salt container Reactivating the water softener Position the salt container as follows Switch on the machine Cleaning the filters in the water cabinet Cleaning and careCleaning the coarse filter Cleaning the fine, flat and micro-fine filters Cleaning the filters in the water inlet Exchanging the S-class particle filter Drying unit TA cleaning and careChanging the Coarse Filter Machine does not start Correcting minor faultsFaults/Possible Causes Position and secure the machine InstallationImportant for machines with DHK steam condensor Cover plate worktop protection Electrical connection To remove service panel and cover plate Electrical connection Connection to the water inlet Plumbing Connection to purified water non- pressurised 0 1.5 bar AD connection to purified water, pressurised, 1.5 10 bar Ventilation of the wash cabinet at rear Drainage Disposal of your old machine Caring for the environmentDisposal of the packing material Noise emission in dB a Technical Data