Installation, Position and secure the machine | Miele G 7783 CD

Installation

Please refer to the Installation diag- ram supplied with the machine.

The machine must be installed cor- rectly and levelled.

Any unevenness in the floor level can be compensated by adjusting the screw feet on the right and left hand sides at the front of the machine.

The service panel must first be lifted off and the cover plate must be un- screwed (see under "Electrical Connec- tion").

When the screw feet are screwed in, the disinfector can be moved back- wards or forwards on its rollers.

The machine can be installed in the fol- lowing ways:

Free-standing *)

Slot-in or at the end of a row: *)

The machine can be installed adjacent to other equipment or furniture or in a recess at least 90 cm wide and 70 cm deep.

*) A machine lid is essential with this type of installation (available as a spe- cial accessory).

Building uner:

The machine should be positioned under a continuous worktop. The niche dimensions must be at least 90 cm wide, 70 cm deep and 82 cm high.

Important for machines with DHK steam condensor:

To avoid steam damage to the worktop the self-adhesive protective sheet sup- plied (25 x 58 cm) should be stuck under the worktop in the area of the condensor.

Position and secure the machine

To guarantee stability the machine must first be aligned and then screwed to the worktop.

35

Image 39

Miele G 7783 CD Installation, Important for machines with DHK steam condensor, Position and secure the machine

Contents

CD Mielabor Contents Guide to the machine 10 11 12 13 Correct usage Page Page Disposal of an old machine Accessories Available at extra cost Description of the machine Setting the WaterSoftener Setting the water softener Reactivating the water softener, see Opening and closing the door To open the door aTo close the door Applications and loading Loading the machineRemoving excess soils Loading example Top basket frame can take various inserts 109106 To adjust the top basket Adjusting the top basket Refilling with rinsing agent Setting the dosageRinsing agent Adding Rinsing agent Adding neutralising agent and liquid detergent Adding neutralising agentAdding detergents Venting the liquid dispensing system / Maintenance Venting the liquid dispensing systemChecking the dispensing system Adding powder detergent Programme B, and when using O-175 or a pipette plate Adding detergentProgramme selection = Cold Programme chart Instructions for the operator 7783 CDPage Page Accessories 93C 70C Programme Changes Switching the machine on and offSelecting a programme Selecting an additional pro- gramme Switching the machine on and off Programme sequence indicator Switching offInterrupting a programme 1a. Cold water connection 1b. Hot water connection1c. AD water connection Programming special functions Filling the salt container Reactivating the water softener Position the salt container as follows Switch on the machine Cleaning the fine, flat and micro-fine filters Cleaning and careCleaning the filters in the water cabinet Cleaning the coarse filter Cleaning the filters in the water inlet Drying unit TA cleaning and care Changing the Coarse FilterExchanging the S-class particle filter Correcting minor faults Faults/Possible CausesMachine does not start Installation Important for machines with DHK steam condensorPosition and secure the machine Cover plate worktop protection Electrical connection To remove service panel and cover plate Electrical connection Connection to the water inlet Plumbing Connection to purified water non- pressurised 0 1.5 bar AD connection to purified water, pressurised, 1.5 10 bar Ventilation of the wash cabinet at rear Drainage Caring for the environment Disposal of the packing materialDisposal of your old machine Noise emission in dB a Technical Data