5.2Plug at least an 18 gauge (AWG) extension cord into the charger plug on the left side of the jump starter. (Extension cord not included; must be purchased separately.)
5.3Plug the extension cord into a 120V AC electrical wall outlet.
CAUTION: Operating the Jump Starter while the internal battery is being charged may cause permanent damage to the unit.
5.4Charging of the internal battery could take up to 48 hours due to the age and condition of the battery. At full charge, the charger will automatically drop into a float mode and maintain the battery at full charge without dam- aging the battery. The jump starter can be left plugged into the 120V wall outlet indefinitely to maintain full power.
NOTE: A fully charged battery will read 100%
5.5Recharge the jump starter after every use and every month (30 days) to extend the battery life.
If the charger is plugged in for over 48 hours and the battery does not fully charge in this time, CHG ERR is shown on the Display. The batteries may be getting old and will no longer accept a charge.
6.powering a 12V dc device
This Jump Starter is a power source for all 12 volt DC accessories that are equipped with a 12V accessory plug. The DC accessory outlet has a
6.1To Operate a 12V DC Device:
•Open the protective cover of the DC power outlet on the front panel of the Jump Starter.
•Plug the 12V DC device into the DC power outlet, and turn the 12V DC device “ON” (if required).
•If the 12V DC device draws more than 15A, the internal circuit breaker of the Jump Starter will stop powering the device. If this occurs, unplug the device and the circuit breaker will automatically reset after several seconds.
•The DC power outlet is wired directly to the internal battery. Extended operation of a 12V DC device may result in excessive battery drain. Re- charge immediately after unplugging the device.
• 4 •
