Schumacher IP-1800I Using the Inverter, Powering a 120V AC Device, Risk of electric shock

Models: IP-1800I 00-99-000990-0809 94026936

1 37
Download 37 pages 11.87 Kb
Page 10
Image 10
5.3Using the Inverter

5.3Using the Inverter

It is important to know the continuous wattage of the device you plan to use with the inverter. The Instant Power™ must be used with devices drawing 400 watts or less. If the wattage is not marked on the device, use only devices that draw less than 4 Amps of AC current.

Devices like TVs, fans or electric motors require additional power to start

(commonly known as the “starting or peak power”). The Instant Power™ can supply a momentary surge in wattage; however even devices rated less than the maximum 400 watts can exceed the inverters surge capabil- ity and cause an automatic overload shutdown.

Do not use the inverter with a product that draws a higher wattage than the inverter can provide, as this may cause damage to the inverter and the product.

Make sure the device you are using is compatible with a modified sine wave inverter.

5.4Powering a 120V AC Device Always run a test to establish whether the inverter will operate a particular piece of equipment or device.

NOTE: In the event of a power overload, the inverter is designed to auto- matically shut down. This safety feature prevents damaging the inverter while testing devices and equipment with the 400 watt range.

NOTE: If powering more than one device, start one device at a time to avoid a power surge and/or inverter overload. The surge load of each device should not exceed the inverter’s continuous operation wattage rate.

5.4Powering a 120V AC Device

To operate a 120V AC device:

1.Ensure the battery clips are securely clipped on the storage holders.

2.Plug the 120V AC device into the AC power outlet, and push the In- verter Switch ON.

NOTE: the CHARGING LED also functions as the INVERTER ON LED

Risk of electric shock. . When you push the inverter switch to the ON position, the LED will light.

3.If the device does not operate properly when first connected to the inverter, push the inverter rocker switch ON (I), OFF (0), and ON (I) again in quick succession. If this procedure is not successful, it is likely that the inverter does not have the required capacity to operate the device intended.

4.Charge the Instant Power™ as soon as possible after each use.

Risk of electric shock.

Incorrect operation of your inverter may result in damage and personal injury. The inverter output is 120V AC and can shock or electrocute the same as any ordinary household AC wall outlet.

6

Page 10
Image 10
Schumacher IP-1800I, 94026936, 00-99-000990-0809 Using the Inverter, Powering a 120V AC Device, Risk of electric shock