14.troubleshooting
PROBLEM | POSSIBLE CAUSE | REASON/SOLUTION |
|
|
|
A battery is connected but | The battery clips are not | Check for a poor connection |
the LCD display still shows | making a good connection. | to the battery and/or frame. |
CONNECT BATTERY |
| Make sure connection points |
|
| are clean. Rock the clips |
|
| back and forth for a better |
|
| connection. |
| The battery connections are | Unplug the charger and |
| reversed. | reverse the clips. |
| The battery is severely | If your battery does not have |
| discharged. | .2V, you must press and |
|
| hold the CHARGE ON/OFF |
|
| button for five seconds to get |
|
| the charge cycle started. |
The LCD display shows: | The battery is defective (will | Have the battery checked. |
CHARGE ABORTED, BAD | not accept a charge). |
|
BATTERY and beeps four |
|
|
times | Weak or sulfated plate in the | Have the battery checked. |
| ||
| battery. |
|
| Wrong battery voltage. | Verify the CHARGE VOLT- |
|
| AGE setting on the charger. |
|
| Make sure it matches the |
|
| battery being charged. |
The LCD display shows: | The battery is bad or | In the case of a severely dis- |
BAD BATTERY and beeps | sulfated. | charged battery, the charger |
four times then switches to |
| will go into abort mode. If, |
CONNECT BATTERY |
| after the output turns off, the |
|
| battery voltage drops to un- |
|
| der .2 volts, the charger will |
|
| reset to the default settings |
|
| and the display will show |
|
| 12V FAST on the top line |
|
| and CONNECT BATTERY |
|
| on the bottom line. |
The LCD display shows: | The charger is not plugged | Plug the charger into an AC |
Nothing | in. | outlet. |
| No power at the receptacle. | Check for open fuse or |
|
| circuit breaker supplying the |
|
| AC outlet. |
| Poor electrical connection. | Check the power cord or |
|
| extension cord for a loose |
|
| fitting plug. |
| Other | Have the battery charger |
|
| checked by a qualified ser- |
|
| vice person. |
• 9 •
