L.

ASSEMBLY INSTRUCTIONS

 

 

Wheel Charger assembly instructions:

NOTE: Unit must be fully assembled before operating

PARTS:

TOOLS NECESSARY:

2 10-32 thread cutting screws

3/8" wrench

2 1/4-20 thread cutting screws

5/16" wrench

2 wheels

hammer

2 axle caps

screwdriver

2 axle brackets

 

1 handle

 

1 mounting foot

 

 

HUBS MUST

 

FACE IN

 

AXLE BRACKET

Fig. A

 

 

Fig. D

First place the charger topside down on a flat surface.

Next mount the mounting foot FIG. A with (2) 1/4-20 screws.

Next pound the axle firmly into an axle cap using a hammer FIG B.

Next slide the wheels onto the axle, hubs must face in, FIG C.

Next pound the other axle cap onto the other end of the axle.

Next place the axle assembly onto the bottom of the charger as shows in figure FIG. C. Mount the axle to the bottom of the charger using the two 10-32 thread cutting screws as shown in Fig. D (these screws require a 5/16" wrench.)

Next turn the battery charger right side up onto its foot and wheels. Remove the two top screws from each side of the charger, line up

the handle and reinstall the screws. FIG E.

Fig. B

—AXLE CAP

Fig. E

TROUBLESHOOTING

If a problem does occur, check the following:

PROBLEM

POSSIBLE CAUSE

SOLUTION

No Meter Reading

Clips are not making

Rock clips back and

(AC Cord Unplugged)

a good connection.

forth for a better connection.

 

Battery voltage is too

Plug AC line into outlet.

 

low.

Meter should now indicate.

 

2 amp charge rate

None, meter will not indicate

 

being used.

here.

Charger will not turn

AC outlet is dead.

Plug in a lamp to check for

on when properly

 

voltage.

connected.

Poor electrical

Check connections, rock

 

connection.

back and forth for a better

 

 

connection.

Clicking noise from

Circuit breaker is

May be in the wrong switch

charger.

cycling.

position

 

Battery is defective.

Have Battery checked.

 

Severely discharged

Allow charging to continue

 

battery but otherwise

until battery has a chance

 

a good battery.

to recover sufficiently to take

 

 

a charge. If more than 20

 

 

min. stop charging and have

 

 

the battery checked.

 

Reverse connections

Shut off charger and correct

 

at battery.

lead connections.

LOCALIZACION DE AVERIAS

Si ocurre algún problema, verificar lo siguiente:

PROBLEMA

CAUSA POSIBLE

SOLUCION

 

 

 

El medidor no indica

La pinzas no están

Mover las pinzas hacia uno y

(cordón CA

haciendo buen

otro lado para lograr mejor

desenchufado)

contacto.

contacto.

 

Voltaje de la bateria

Enchufar el cordón CA al

 

demasiado bajo.

tomacorriente; ahora el

 

 

medidor debe indicar.

 

 

 

El cargador no se

El tomacorriente CA

Enchufar una lámpara para

enciende cuando

no tiene electricidad.

verificar si hay voltaje.

está bien conectado.

Mala conexión

Revisar las conexiones,

 

mover hacia uno y otro lado

 

eléctrica.

 

para lograr mejor contacto.

 

 

 

 

 

El cargador hace

El disyuntor de

Puede estar en la posición

ruido (“clic”)

circuito está

errónea del interruptor.

funcionando.

 

 

Hacer revisar la batería.

 

 

 

La batería está

Dejar cargando hasta que la

 

defectuosa.

 

batería tenga oportunidad de

 

 

 

Batería demasiado

recuperarse lo suficiente para

 

tomar carga. Si se demora

 

descargada, pero

 

más de 20 minutos, parar de

 

buena.

cargar y hacer revisar la

 

Invertir las conexiones

batería.

 

Apagar el cargador y corregir

 

en la batería.

 

 

las conexiones de los

 

 

conductores.

LIMITED WARRANTY

SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MOUNT PROSPECT, IL 60056-2179 MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE.

Schumacher Electric Corporation warrants this battery charger for 3 years, and the transformer and rectifiers for 5 years from date of purchase at retail against defective material or workmanship. If such should occur, the unit will be repaired or replaced at the option of the manufacturer. It is the obligation of the purchaser to forward the unit together with proof of purchase, transportation and / or mailing charges prepaid to the manufacturer or its authorized representative. This limited warranty is void if the product is misused, subjected to careless handling, or repaired by anyone other than the factory or other authorized factory representative. The manufacturer makes no warranty other than this limited warranty and expressly excludes any implied warranty including any warranty for consequential damages.

This is the only express limited warranty and the manufacturer neither assumes nor authorizes anyone to assume or make any other obligation towards the product other than this express limited warranty. The manufacturer makes no warranty of merchantability or fitness for purpose of this product and expressly excludes such from this limited warranty. Some states do not allow the exclusion or limitation of incidental or consequential damages or length of implied warranty so the above limitations or exclusions may not apply to you. “This warranty gives you specific legal rights, and you may have other rights which vary from state to state.”

Sch487

6

Page 6
Image 6
Schumacher SE 3612 owner manual Assembly Instructions, Troubleshooting, Localizacion DE Averias, Parts Tools Necessary