Installing the Dense QAM Array PSU, Continued
To Install the Dense QAM Array PSU
When you have read the safety guidelines and precautions, you are ready to install the PSU in the Continuum DVP Dense QAM Array Chassis or in the Mercury Dense QAM Array Chassis.
Perform the following procedure to install the PSU.
1.Unpack the PSU.
CAUTION:
Follow proper ESD handling procedures.
ESD may cause permanent damage to electronic components.
When unpacking a unit, examine it, the accessories, and the packing material for obvious signs of damage. Check the unit against the delivery/packing note. Retain the packing material, as it is required for warranty shipments and for later inspection by the carrier. Should any item be damaged, notify the carrier and your
2.Loosen the three screws at the front of the chassis and open the front cover.
3.Slide the card in the card guides of the
Continued on next page
6984278 Rev A | Installation |
