About iPod software version
The iPod software versions that can be used with this unit are as follows (operations verified as of August 2008):
iPod (5th generation) | ver: 1.3 |
iPod classic | ver: 2.0 |
iPod nano (1st generation) | ver: 1.3.1 |
iPod nano (2nd generation) | ver: 1.1.3 |
iPod nano (3rd generation) | ver: 1.1.2 |
iPod nano (4th generation) | ver: 1.0.0 |
iPod touch | ver: 2.0 |
iPhone 3G | ver: 2.0 |
*Please note that no guarantee applies to iPod operations and future updated versions of iPod software.
Connecting the iPod
Connect the USB connector.
Connect the iPod as indicated in the figure below using an optional cable.
iPod with Dock connector port
USB port
*1 | To the vehicle's |
| |
| USB connector |
| *2 |
Dock connector 1 ft. 6 in. (45 cm) | |
When connecting the iPod, remove a headphone cable from the iPod.
*1 Use an optional car audio cable.
*2 Connection location differs depending on the vehicle.
Vehicle type Connection location
xB | Connect to the USB connector |
| near the parking brake. |
xD | Connect to the USB connector |
| near the cup holder. |
As soon as the iPod is connected, its power is automatically turned on. While the iPod is connected to this unit, SCION (or 
(check mark)) is displayed on the iPod.
•When the ignition switch is set to ACC or ON, the iPod's battery is charged while the iPod is connected to this unit.
•While the iPod is connected to this unit, the iPod itself cannot be turned on or off.
•The iPod connected to this unit is turned off about two minutes after the ignition switch is set to OFF.
NOTICE
To resolve most problems when using your iPod with the Scion Audio system, disconnect your iPod from the vehicle iPod connection and reset it.
For instructions on how to reset your iPod, refer to your iPod Owner’s Manual.
17
