Scotsman Ice NME654 REMOVAL AND REPLACEMENT Bin Controls, NME454, 654 & FME504, Reservoir

NME454, 654 & FME504, 804

REMOVAL AND REPLACEMENT: Bin Controls

BIN CONTROLS (Ice Level Sensors)

1.Disconnect electrical power.

2.Remove front panel.

3.Remove control box cover.

4.Locate ice chute, at the base of the chute, in front of and behind it are two plastic bin control mounts.

5.Slide each bin control to the left, and in the control box, disconnect the electrical leads connecting the bin control to the circuit board.

6.Reverse to reassemble, be certain that the bin controls are aligned so that the ice level sensors are visible (centered) through the holes in the ice chute.

SLIDE BIN

CONTROLS

LEFT AND

RIGHT

ICE

CHUTE

RESERVOIR

1.Shut off water supply.

2.Remove front panel.

3.Remove reservoir cover.

4.Disconnect water inlet tube from reservoir inlet fitting.

5.To remove float valve, push in on “Locking Tab” as shown and pull valve up.

Note: The plunger/seat is available as a separate part.

6.To remove reservoir, pull up and remove water sensor.

7.Disconnect water outlet tubes.

8.Remove the two screws holding reservoir to bracket.

9.Remove reservoir from ice machine.

10.Reverse steps 1-9 to reassemble.

FLOAT
ASSEMBLY	Water
	Sensor

LOCKING

TABS

January 2007

Page 14