ADJUSTMENT
OF SEATPOST-HEIGHT
Important:
The seatpost has to be inserted into the seat- tube at a minimum of 100mm.
Never use another seatpost diameter than 34.9mm or try to use a shim/reducer between seatpost and frame.
In case your bike is equipped with an integrated seatpost pls follow the instructions below to cut the seattube to your personal length.
The seatpost of the Scott Spark needs to be cut and adjusted to the personal seat height of the rider.
The tool to do so is added to your Spark and will help to cut properly without any risk of damaging your seat tube.
To do so, pls follow the instructions given below:
1.Take the exact measure of the distance (d1) from the mid of axle of your pedal to the upper side of the saddle you use already on your “old” bike which is exactly adjusted to your seat position.
Important: pls note that the change to another saddle or pedal model might influence a lot the length of the seat tube!
2.Mount your pedals and saddle on the Spark bike. Fix the saddle with the M5 screws (4mm Allen key) by using a tightening torque of 5Nm (44
Your Spark seat clamp allows you to vary the seat |
|
height for fine adjustment of +/- 10mm. For the cutting, |
|
position your seat clamp as low as possible and measure | … |
the distance (d2) from the mid of the pedal axle to the |
|
upper side of the saddle. |
|
Remove the seat clamp and measure the distance (l) |
|
from the top of the seat tube: l = d2 – d1 |
|
ENGLISH
DEUTSCH
FRANÇAIS
integrated seatpost | standard seatpost |
| OWNER’S MANUAL 2007 |
|
14 | 15 |
