Manuals / Sea Frost / Kitchen Appliance / Ice Maker

Sea Frost BG 2000 installation instructions Recharge. Refer to Recharging section

Models: BG 2000

1 37

Download 37 pages 59.01 Kb

Page 29

Follow the "re-make" instructions for Swagelok fittings.

Reminder: To ensure the total removal of moisture from the system use a high vacuum pump, and evacuate the system with the highest possible plate temperature (100 degrees F.). A light bulb or heat lamp in contact with the plates is a good technique.

Recharge. Refer to "Recharging section"

MOISTURE IS A SYMPTOM. Carefully leak check the low side of the system if moisture becomes a problem. Moisture leaks in!

CALL US WITH ANY QUESTIONS

INTERNATIONAL 603-868-5720

TOLL FREE IN THE UNITED STATES,

CANADA, AND CARIBBEAN

800-435-6708

FAX 603 868 1040

SHIPPING AND MAIL:

SEA FROST

372 ROUTE 4

BARRINGTON NH 03825

USA

29

Image 29

Sea Frost BG 2000 installation instructions Recharge. Refer to Recharging section

Contents

OPERATION & INSTALLATION INSTRUCTIONS BG TABLE OF CONTENTS A VIEW OF THE FUTURE CONTROLS BG 2000 OPERATIONHARVESTING ICE ICE MAKINGSTORAGE OF ICE CUBES DEFROSTINGCLEANING BG 2000 MAINTENANCEROUTINE SERVICE AND INSPECTION ROUTINELY CHECKLAY-UPWinterizing CHECKING THE REFRIGERANT CHARGESIGHT GLASS LOCATION HOW REFRIGERATION WORKS By causing R-404ato boil evaporate in the SEAFROST plates, we absorb the heat energy there. This activity cools the liquid solution within the plates, causing them to change phase freezing to a solid. By freezing this solution, we have increased its heat absorption capacity more than 100 times TUBE HANDLING INSTALLATIONTUBE CUTTING TUBE BENDINGNOTES ON SWAGELOK FITTINGS STEP DRAWINGSTEP RECONNECTING PRE-SWAGEDFITTINGS CONDENSING UNIT LOCATION AND MOUNTING SERVICE ACCESSRECEIVER FILTER DRIER RFD VISIBILITY MOUNTINGINSTALLING THE THERMOSTATIC EXPANSION VALVE WARNING READ SAFETY SECTION BEFORE PROCEEDING PUMP INSTALLATIONFINAL ASSEMBLY RUNNING THE TUBINGCONNECTION ACCESS THERMOSTAT WIRINGRFD Receiver Filter Drier THERMOSTATREFRIGERANT HANDLING AND SAFETY WIRING THE PUMPGENERAL SAFETY THIS IS IMPORTANT. READ THIS REFRIGERANTACCESS TO THE SYSTEM SERVICE PORTS PROCEDURES FOR WORKING WITH R-404aVENTING THE GAUGE SET DISCONNECTING GAUGESGAUGES COMMISSIONING PROCEDURE WHEN ATTACHING GAUGES TO A CHARGED SYSTEMVENTING THE CHARGE HOSE LIQUID CHARGINGLEAK CHECKING A CHARGED SYSTEM ABOUT PRESSURES NEW SYSTEM CHARGING INTRODUCING INITIAL CHARGELEAK CHECKING TO CHECK WITH AN ELECTRONIC DETECTOR TO CHECK WITH BUBBLESIF A LEAK IS DETECTED SPECIAL NOTEREADING THE SIGHT GLASS GENERAL INFORMATION RFD SIGHT GLASS DETAILPROPER CHARGE AMOUNT CHECKING THE REFRIGERANT CHARGE SPECIAL NOTEPERIODIC INSPECTION DISCHARGING THE SYSTEM RECLAIMINGHIGH PRESSURE CUTOUT/MANUAL RESET BUTTON TROUBLESHOOTINGSuctionline from valve remains warm Recharge. Refer to Recharging section Pressure trends Gauge pressure PSIG 115-volt50/60 hz230-volt50/60 hz Page WATER CIRCUIT Page Page Page THERMOSTAT CALIBRATION INSTRUCTIONS HOLDOVER PLATES STAINLESS STEEL EVAPORATOR PLATES