Manuals
/
Seagate
/
Kitchen Appliance
/
Ventilation Hood
Seagate
1080SL manual Seagate Technology, Inc 920 Disc Drive, Scotts Valley, CA 95066, USA
Models:
1080SL
1
28
28
Download
28 pages
14.67 Kb
21
22
23
24
25
26
27
28
<
>
Troubleshooting
Install
Error codes
Configuring the drive
Options jumper settings
J3. Standard power connector
Technical support services
nators enabled. If you are positioning the drive at the end of the cable, you must enable the drive’s internal terminators or attach an external terminator to the end of the cable. Terminators on the devices between the bus ends must be disabled or removed
Drive features
Page 28
Image 28
Seagate Technology, Inc.
920 Disc Drive, Scotts Valley, CA 95066, USA
Publication Number:
36325-001,
August 1995, Printed in USA
Page 27
Page 28
Image 28
Page 27
Contents
Medalist 1080sl
Installation Guide
SCSI Interface Drive
Contents
Configuring the drive
Configuring the drive and computer
Basic troubleshooting
Introduction
Drive features
Read before you begin
Sicherheitsanleitung
Configuring the drive
Required materials
Figure 1. Connector and jumper block locations
J8. Options jumper block J8 pin J1 pin J1. Interface connector
J3. Standard power connector
Circuit
Figure 2. Options jumper settings
assign ID values 0 through 7. Be sure that the ID you choose is not used by another device on the SCSI bus
nators enabled. If you are positioning the drive at the end of the cable, you must enable the drive’s internal terminators or attach an external terminator to the end of the cable. Terminators on the devices between the bus ends must be disabled or removed
Attaching cables
3. Attach an available power cable to the drive
Required materials
Figure 3. Mounting hole locations
Mounting the drive
Required materials
System setup configuration
Configuring the drive and computer
Low-level formatting
Partitioning
3. Select create DOS partition or logical DOS drive. Press ENTER
High-level formatting
Network installation
NonDOS operating systems
Basic troubleshooting
Page
Advanced troubleshooting
System error message, “Drive not Ready,” appears
The screen stays blank when you power up the system
The FDISK error message, “No Fixed Disk Present,” appears
Technical support services
SeaBOARD
Location
Modem number
SeaFAX
Telephone number
Seagate Technical Support FAX. 408/438-8137
SeaFONE. 408/438-8222
Seagate CompuServe forum
SeaTDD. 408/438-5382
Seagate’s Internet connections
Storing and shipping your drive
Figure 4. A drive in an approved package
Page
Seagate Technology, Inc 920 Disc Drive, Scotts Valley, CA 95066, USA
