Seagate 1080SL manual Configuring the drive, Required materials

Medalist 1080sl SCSI Installation Guide, August 1995 5

3.Als Versorgungsspannugen werden benötigt:

+5V æ 5% 0,65A

+12V æ 5% 0,45A (1,9A fur ca. 10 Sek. fur æ 10%)

4.Die Versorgungsspannung mub SELV entsprechen.

5.Alle Arbeiten auf dem Festplatte dürfen nur von Ausgebilde- tem Servicepersonal durchgeführt werden. Bitte schaffen Sie Festplatteetiketten nicht weg.

6.Der Einbau des Drives mub den Anforderungen gemäb DIN IEC 950V DC 0805/05.90 entsprechen.

Configuring the drive

Required materials:

2-mm jumper connector (supplied as spare jumpers)

Your Seagate drive is configured for operation using the options jumper block (J8) shown in Figure 1 on page 6. The settings for the available configurations are shown in Figure 2 on page 7. The options jumper block (J8) allows you to:

∙Set the SCSI ID

∙Connect a remote LED

∙Enable or disable parity

∙Enable or disable the drive’s terminator

∙Select the termination power source

SCSI ID settings. Each device on the SCSI bus must be as- signed a unique SCSI ID. The drive uses pin-pairs 1 and 2, 3 and 4, and 5 and 6 on the options jumper block (J8) for assigning the ID. The chart in Figure 2 shows you how to place the jumpers to