Appendix. Compatibility notes, ECC testing | Seagate 810 specification

Marathon 810 (ST9816AG) Product Manual, August 1995	29

Appendix. Compatibility notes

ECC testing

When an ST9816AG performs hardware-based ECC error correction on-the-fly, the drive does not report an ECC error. This allows ECC correction without degrading drive performance. Some older drive diag- nostic programs test ECC features by creating small data errors and then checking to see if they are reported. These tests, when run on an ST9816AG, may incorrectly report an ECC detection failure because the drive hardware corrects the data automatically, avoiding the error rather than reporting it. This type of report does not indicate a drive malfunction.

Image 37

Seagate 810 manual Appendix. Compatibility notes, ECC testing

Contents

Marathon ATA Interface Drive Page Marathon 810 ST9816AG ATA Interface Drive Page Contents ATA interface Drive mounting and configurationAppendix. Compatibility notes Figures Page Introduction Drive Specification ST9816AG Specification summary table Read/Write power and current typical Page Default logical geometry Drive specificationsFormatted capacity Supported translation geometries Recording and interface technology Physical dimensions Power consumption Power specificationsSeek time Startup times Typical current profile Typical watts RMS Typical amps RMS Mode At nominal voltage Power-management modes Power recoveryConducted noise Voltage tolerance Temperature gradient Environmental tolerances Ambient temperatureRelative humidity Shock AltitudeOperating shock Nonoperating shock Nonoperating vibration Mode TypicalDrive acoustics Reliability FCC verification Agency certification Safety certification Marathon 810 ST9816AG Product Manual, August Handling and static-discharge precautions Drive mounting and configurationJumper settings Master/slave configuration Connector and master/slave jumper setup for the ST9816AG Jumper For pins Configuration Remote LED configurationDrive mounting Mounting dimensions for the ST9816AG Dimensions are in inches mm ATA interface connectorPage AT bus signal levels ATA interface signals and connector pinsATA interface O pins and associated ATA signals supported by the ST9816AG NOP ATA Interface commands Supported ATA commands ATA-standard power-management commands Command Supported by Command name Code ST9816AGSeagate-specific commands Word Description ST9816AG Identify Drive command Xxxx H Word Bit Description if bit is set to Set Features command Appendix. Compatibility notes ECC testing