Seagate ST12400W/WD/WC, ST11900W/WD/WC manual Hawk 2 Wide bus Family Install Guide, Rev. C

30	Hawk 2 (Wide bus) Family Install Guide, Rev. C
continued from previous page
Off	On	Drive spindle does not start until Start Unit com-
		mand received from host.
On	Off	Spindle Startup is delayed by SCSI ID times 12
		seconds after power is applied, i.e., drive 0
		spindle starts immediately when DC power con-
		nected, drive 1 starts after 12 second delay, drive
		2 starts after 24 second delay, etc.
On	On	Drive spindle starts when Start Unit command
		received from host. Delayed start feature is over-
		ridden and does not apply when ME jumper is
		installed.
WP
On		Entire drive is write protected.
Off		Drive is not write protected. Default is no WP
		jumper installed.
PE
On		Parity checking and parity error reporting by the
		drive is enabled. Default is PE jumper installed.
Off		Drive does not report result of parity checking to
		host.
TE		(Applies to "W" models only)
On		With the jumper installed, the optional on-board
		(non-removable) terminator circuits are enabled
		(connected to the I/O lines). Default is jumper
		installed.
Off		Terminator circuits not connected to I/O lines.