Configuring and mounting the drive | Seagate ST3250310SV guide

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive by its edges or frame only.

•The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

SV35.3 Series Serial ATA Product Manual, Rev. B

23

Image 29

Seagate ST3250310SV, ST31000340SV manual Configuring and mounting the drive, Handling and static-discharge precautions

Contents

ST31000340SV ST3750330SV ST3500320SV ST3250310SV SV35.3 Series Serial ATA Revision Date Revision history Contents SV35.3 Series Serial ATA Product Manual, Rev. B List of Figures Page Introduction About the Serial ATA interface Specification summary tables Drive specifications Drive specification ST31000340SV ST3750330SV ST3500320SV System will display the warranty information for your drive Drive specification ST3250310SV Drive specifications summary for 250 Gbyte models Tem will display the warranty information for your drive LBA mode Default logical geometryFormatted capacity Cylinders Read/write heads Sectors per track Drive specification Physical characteristicsRecording and interface technology Models ST31000340SV, ST3750330SV & ST3500320SV ST3250310SV Start/stop times Seek timeTypical seek times msec Read Write TB models GB models Power specifications DC power requirements Voltage tolerance Conducted noise Active mode Power-management modesIdle mode Sleep mode Environmental specifications Operating shock ShockNonoperating shock 4, 3 and 2 disc models Nonoperating shock 1 disc models Electromagnetic immunity AcousticsFluid Dynamic Bearing FDB motor acoustics Radio frequency environments Reliability Agency certification China Restriction of Hazardous Substances RoHS Directive Environmental protection Corrosive environment SV35.3 Series Serial ATA Product Manual, Rev. B Handling and static-discharge precautions Configuring and mounting the drive Serial ATA cables and connectors Configuring the drive Drive mounting Mounting dimensions-top, side and end view SV35.3 Series Serial ATA Product Manual, Rev. B Hot-Plug compatibility Serial ATA Sata interface Serial ATA connector pin definitions Serial ATA device plug connector pin definitionsSignal PowerPage Command name Command code in hex Supported ATA commandsSupported ATA commands F6H E8H Word Description Value Identify Device command XxxxH Xx3FH Bit Word Description if bit is set to Bit Word Set Features command values Set Features command F1 H Code in features register A.R.T. command 3 S.M.A.R.T. commandsA.R.T. commands SV35.3 Series Serial ATA Product Manual, Rev. B Technical Support InternetPresales Support Data Recovery Services Call Center Toll-free Direct dialFAX Warranty ServiceData Recovery Services Authorized Service Centers Index ITE Page SV35.3 Series Serial ATA Product Manual, Rev. B Page Seagate Technology LLC