Hawk 2LP Family Installation Guide, Rev. B | 17 |
_____________________________________________________________________________________________________________
Initial set-up information
For the initial setup connect the cables or plug into a mounted connector (if applicable), set the drive ID on the bus and enable or disable the I/O line terminator IC ("N" models). These procedures are described in para- graphs following. Note whether drive model number ends in N or ND.
SCSI interface cable connection
Models Hawk 2LP family are SCSI interface drives. System connection is via a 50 pin SCSI connector. Pin 1 is noted in Figure 2. Some cables have a contrasting color stripe on one edge to indicate pin 1. Strain relief is recommended at the cable in drives using cables. Do not block system cooling air flow in routing of cables.
