Hawk 2LP Family Installation Guide, Rev. B | 31 |
_____________________________________________________________________________________________________________
•Verify that all connections between the drive and the host system are correctly installed. Most cables have a contrasting color stripe indicating pin 1. Pin 1 on the drive I/O connector and the DC power connector are indicated in the figures in the Initial
•Verify option select and drive ID select jumpers and installation of terminator enable jumper where appli- cable. See Drive Configuration section.
Do not power up the host system until the drive is mounted and the system cover is replaced.
•Connect DC power connector to the drive.
•Replace the Host System cover.
•Turn on DC power.
•Boot the system from the floppy drive or from a previously installed