Powermate P-WB-163150 Operation Continued • Save all instructions, C How to Stop the Blower

Operation (Continued)

• Save all instructions

C How to Stop the Blower

Move the ON/OFF Switch to the OFF position. (See figure 6)

D How to Adjust the Vertical Flow Angle

The vertical air flow direction can be adjusted between 3 positions: Straight (level), 15 degrees upward, and 15 degrees downward. Refer to Figure 8 when performing the adjustment steps below:

1.Stop the engine.

2.Pull the index lever out of its existing hole.

3.Rotate the index lever to the desired position.

4.Release the index lever and allow it to insert into the desired hole.

WARNING

Never adjust the flow angle when engine is running. Never stand or put your hand in front of the discharge opening when the engine is running. Never put hands, fingers, or anything else inside the discharge opening when the engine is running. There are rotating blades inside which can cause serious injury.

15° Downward
Level		Air Flow
15° Upward		Louver
	Adjustment
	Lever	Figure 8

E How to Redirect Air Flow toward the Front

A Front Flow Attachment is included with your blower. Assembling this attachment to the blower will cause the air flow to
be redirected to the front of the blower.
To assemble this attachment to the blower, follow the steps
below and refer to Figure 9:
1.	Stop the engine.				Bolt
2.	Rotate the vertical adjustment lever to the level position				Slot
	(See Figure 8)
3.	Loosen the attachment knob located on top of the blower			Front Flow
				Attachment
	discharge chute
4.	Orient the attachment so the “This Side Up For USE” is up.			Discharge
5.	Slide the front flow attachment over the discharge			Chute
	chute with the orientation identified on the label. The slot
	on the top of the front flow	attachment will	mate
	with the bolt of the attachment knob.		the
6. Hand-tighten the attachment		knob to secure
	attachment.			Attachment
Note: when properly assembled, the attachment knob will fit				Knob
				Round
inside of the round emboss on the top of the attachment.
				Emboss

Figure 9

Questions? Call Toll Free at 1-800-737-2112 10 Copyright © 2009 MAT Engine Technologies, LLC