Momentus 5400.3 PATA Blade Server Product Manual, Rev. B
21
3.0 Configuring and mounting the drive
This section contains the specifications and instructions for configuring and mounting the drive.

3.1 Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis-
charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:
Caution:
Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s
exposure to ESD.
Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal
chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap thr oughout the entire
installation procedure.
Handle the drive only by its edges or frame.
The drive is fragile—handle it with care. Do not press down on the drive top cover.
Always rest the drive on a padded, antistatic surface until you mount it in the computer.
Do not touch the connector pins or the printed circuit board.
Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids
the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are
used to seal out dirt and contamination.