Seagate ST94015AS, ST980825AS, ST96023AS Configuring the drive, Serial ATA cables and connectors

3.2Configuring the drive

Each drive on the Serial ATA interface connects in a point-to-point configuration with the Serial ATA host adapter. There is no master/slave relationship because each drive is considered a master in a point-to-point relationships. If two drives are attached on one Serial ATA host adapter, the host operating system views the two devices as if they were both “masters” on two separate ports. This means both drives behave as if they are Device 0 (master) devices.

Serial ATA drives are designed for easy installation with no jumpers, terminators, or other settings. It is not nec- essary to set any jumpers on this drive for proper operation. The jumper block adjacent to the signal connector is for factory use only.

SATA Signal

Jumper Block	SATA Power
(factory use only)

Figure 2. Serial ATA connectors

3.3Serial ATA cables and connectors

The Serial ATA interface cable consists of four conductors in two differential pairs, plus three ground connec- tions. The cable size may be 30 to 26 AWG with a maximum length of one meter (39.37 inches). See Table 7 for connector pin definitions. Either end of the SATA signal cable can be attached to the drive or host.

For direct backplane connection, the drive connectors are inserted directly into the host receptacle. The drive and the host receptacle incorporate features that enable the direct connection to be hot pluggable and blind mateable.

For installations which require cables, you can connect the drive as illustrated in Figure 3.

Signal connector

Power connector

Signal cable

Power cable

Figure 3. Attaching SATA cabling

Each cable is keyed to ensure correct orientation.

20 Momentus 7200.1 SATA Product Manual, Rev. B