Section 2. Operating Procedures

2. Pre-heat the Laminator

All Pre-heat control operations are controlled from the Control Panel as shown in Figure 2.2

1.Switch machine to START at the Main Power Switch

Laminator will power-up

Dryer Panel is in the UP position.

Heaters are OFF.

Set Button

Up Button

Down Button

Figure 2.2 Heater Control locations

2.On the Heater Controller, press and hold the SET button to check the set-point temperature. Adjust the set point by holding the SET button down and using the UP/DOWN arrows to scroll to the desired temperature setting.

Note: Most vinyl’s run well with a SET POINT temperature of 315°C (600°F) dependent on speed.

3.Press the Heater Switch to ON to power the Dryer Panel and begin heating.

4.Once the machine reaches its SET POINT it is ready to be operated.

12

Page 13
Image 13
SEAL AS-1600 operation manual Pre-heat the Laminator, Heater Control locations