Section 2. Operating Procedures
16
5. Cleaning the Laminator
1. It is important to clean the machine immediately after the end of the material is
completely through the Dryer panel.
2. Switch the machine to Stop on the Main Power Switch.
3. Pull Drip tray out 6 inches and raise the draw down assembly for cleaning.
Figure 2.6 Clean Up View
4. Using a WET cloth, wipe the 2 draw down bars to remove any excess sealant
from them.
Note: Sometimes the tail end of the material will drag a little coating onto the
stainless steel table behind the Draw Down Assembly. It needs to be
cleaned off quickly because the heat from the Dryer Panel will dry it
rapidly.
5. Dry the Draw Down bars with a clean dry cloth.
6. Put cap back on Applicator Nozzle.