TABLE OF CONTENTS
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 2 Recommendations . . . . . . . . . . . . . . . . . . . . 2 Installation Instructions . . . . . . . . . . . . . 2 - 4 Operating Instructions . . . . . . . . . . . . . . . . . 4 Maintenance . . . . . . . . . . . . . . . . . . . . . . 4 - 5 Preparing for Summer Use . . . . . . . . . . . . . 5 Model Identification . . . . . . . . . . . . . . . . . . . 5 Spare Parts . . . . . . . . . . . . . . . . . . . . . . . . . 5 Customer Service . . . . . . . . . . . . . . . . . . . . 5 Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Troubleshooting Guide . . . . . . . . . . . . . . . . 7 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
SPECIFICATIONS
Product Name:
Shipping Information:
Carton Sizes:
Toilet 21" x
(533mm x 470mm x 343mm)
Tank | |
| (489mm x 445mm x 292mm) |
Weight | Approx. 49 lbs. (22Kg) |
System:
Average water consumption per flush 1 Qt. (.95L) Minimum water consumption per flush 1 Pt. (.47L) Holding tank capacity . . . . . . . . . . . 9.5 Gal. (36L) Fresh water supply pressure . . . . . . . . . .
Dimensions:
RECOMMENDATIONS
1.Read the “Operating Instructions” section of the manual carefully.
2.Make sure all guests understand the operation of the Traveler toilet.
3.Carry a few spare parts for the maintenance purposes. SeaLand has developed several repair kits that will save you both time and expense should a problem occur. See “Customer Service” section of this manual.
4.Use only SeaLand brand® Tissue and Secure® liquid or SeaLand® brand Holding Tank Deodorants to maintain a
5.Do not use chlorine or caustic chemicals, such as laundry bleach or drain opening types, in the system. These products damage the seals in toilets.
6.Do not flush foreign objects through the toilet.
7.Do not allow small problems to go unsolved. As soon as a problem is detected, correct it.
INSTALLATION INSTRUCTIONS
Tank:
1.Select position in bathroom where unit can operate properly. Allow room for using the flush lever and clearance for raising the seat and lid.
2.Position the tank 3/4" (19mm) away from the wall. Mark four holes at mounts on tank base. After holes are marked, remove tank, and drill pilot holes. Slide tank back into position. Secure the tank with four #14 x 2" long pan head screws and washers on all tank mounts.
3.Run 5/8" (16mm) I.D. hose to vent fitting and secure with hose clamps.
Install thru-hull vent fitting:
(not supplied with unit – SeaLand part number 346368)
4.Drill hole through the hull, well above water line and directly above Traveler toilet. Hole location is deter- mined by routing and length of hose.
2