INSTALLATION INSTRUCTIONS (cont'd)
Water line:
17.Locate water valve at rear of flush lever.
18.Attach water supply pipe or hose from water system to inlet fitting on back of water valve.
Pedestal cover:
19.Slide back side of pedestal cover around rear of toi- let base and snap in groove. Close front half of ped- estal cover and snap in groove.
Flush pedal cover:
20.Put flush pedal cover back in place.
Seat and lid:
21.Remove seat and lid from package. Secure to china bowl using instructions from mounting pack.
OPERATING INSTRUCTIONS
To properly use the Traveler® toilet, follow these simple instructions:
1.A good biodegradable tissue such as SeaLand® brand is recommended.
2.To add water to the toilet before using, lift or raise the flush pedal.
3.To flush toilet, push pedal all the way down until sewage leaves the toilet bowl. Water flow pressures vary at different locations and therefore, holding the flush lever down
4.Release flush pedal by allowing it to snap back, which permits positive sealing around the flush ball.
5.A small amount of water should remain in the bowl.
Note: Holding the flush pedal down longer than neces- sary results in excessive water usage.
CAUTION: Do not dispose of sanitary napkins or other
MAINTENANCE
CLEANING
The Traveler toilet should be cleaned regularly for maxi- mum sanitation and operational efficiency.
Clean the toilet bowl with a mild bathroom cleaner, such as SeaLand’s Brilliance™ thick liquid toilet bowl cleanser. Do not use chlorine or
If an odor is apparent from the toilet:
1.Clean out system by flushing several gallons of fresh water through with one cup of dry laundry soap.
2.Add odor control deodorant in amount specified for your holding tank capacity after cleaning and every few days during use.
WINTERIZING
At the end of each season, the Traveler toilet should be winterized for storage by either draining or using potable water safe antifreeze in the system.
To drain:
1.Thoroughly flush system with fresh water.
2.Empty holding tank.
3.Shut off water supply to toilet. Remove inlet waterline.
4.Press flush lever until all water is drained from toilet.
4