SeaLand 711-M28 INSTALLATION INSTRUCTIONS cont’d, Dockside Discharge Fitting, Toilet Installation

INSTALLATION INSTRUCTIONS (cont’d)

5.Apply waterproof caulk around underside of thru-hull vent fitting.

6.Install thru-hull vent fitting and secure snugly with nut. Wipe off excess caulk with damp cloth.

7.Attach remaining end of vent hose to thru-hull fitting with hose clamp.

Dockside Discharge Fitting:

(not supplied by SeaLand)

8.Drill hole in deck directly above Traveler toilet. Hole location is determined by routing space and length of hose.

9.Screw 1-1/2" FPT x 1-1/2" hose barb into bottom of deck fitting.

10.Apply waterproof caulk around deck hole and install deck fitting into 2-1/4" (57mm) hole with screws. Wipe off excess caulk with a damp cloth.

11.Install 1-1/2" MPT x HUB adapter into discharge fit- ting on holding tank.If necessary, PVC cement el- bow and hose adapter or hose adapter only into 1-1/2" (38mm) adapter. Secure 1-1/2" (38mm) hose to adapter with hose clamp.

or

12.Route hose from tank to deck fitting and secure with hose clamp.

Note: The holding tank on the 711-M28 is designed to withstand discharge by a properly operating discharge pump.

Toilet Installation:

13.Push button on back of flush pedal, then pull flush pedal cover away from pedal to expose water valve. Remove plastic pedestal cover from toilet base.

14.Install the (4) 1/4-20 x 1-3/4" long studs in inserts on the tank top.

15.Place floor flange seal on studs, aligning the studs with bumps on seat. Note: “THIS SIDE UP” should face upwards.

16.Place toilet on studs and secure with four washers and four nuts.

3