![](/images/new-backgrounds/1261801/261801137x1.webp)
How to set-up the Waterproof Housing
Set up camera
1.Insert fully charged lithium battery into camera.
2.Clean camera lens with dry, clean cotton swab.
3.Remove camera strap since this will prevent the camera from correctly seating itself inside the housing.
4.Set camera to Sea mode (when not using External Flash accessory) or External Flash mode (If using External Flash accessory). See page 21 for detailed instructions on how to set camera to Sea or External Flash modes.
Set up housing
Opening and loading of the housing should be done in a dry environment such as in an
1.Open the housing by pushing in small locking tab and lift latch up. Do not extend housing lid beyond its stop point or damage may occur to the hinge area.
2.Carefully inspect
3.Clean the housing glass lens port using clean, dry cotton cloth. It is recommended to apply
4.Carefully insert camera into housing. Make sure camera is clean and dry.
5.Insert one Moisture Muncher
6.Carefully clean
How To Open And Close Waterproof Housing >>
67