Sears 139.53627SRT Install the Lights and the Lenses, Install the lights, Install the lenses

Installation Step 7	I
Install the Lights and the Lenses

Install the lights:

•Install a 75 watt maximum light bulb in each socket. The lights will turn ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the lights will turn OFF.

•If the bulbs burn out prematurely due to vibration, replace them with standard neck "Garage Door Opener" bulbs.

Install the lenses:

•Apply slight pressure on the sides of each lens and slide the tabs into the slots in the side panels.

•For convenience, the lenses may be installed after Adjustment Step 4 on page 30.

•Reverse the procedure to remove the lenses.

		75WattMax
Lens	_	Light Bulb
Tab

Lens

Tab

Lens _

Tab

Lens

Guide

Lens

.... Stot

Installation		Step 8
Attach	the Emergency
Release	Rope	and Handle	Do not	use the red	handle to pull the door
			open or closed. The rope knot could become
			untied and you could fall. Use the emergency
			release only to disengage the trolley and, if
			possible, only when the door is closed.
			Garage doors are heavy. If the door is open
			when the handle is pulled, the door could
			close	inadvertently	if it is not properly
			balanced. Serious injury may result to persons

under the door. Make sure the doorway is clear

of persons and obstructions before pulling handle when door is open.

Tro,

Rope

_

Overhand

Knot _ )

°v£h° nd

Release Arm

Emergency

Release Handle

•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot.

The knot should be at least 1" from the end of the rope to prevent slipping.

•Thread the other end of the rope through the hole in the release arm of the outer trolley.

•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot.

If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.

19