Sears 139.53640SRT Receiver and Remote Control Programming, Mini 3-Function Remote Control

Receiver and Remote Control Programming

To comply with FCC rules, adjustment or modifications of this receiver] and/or transmitter are prohibited, except for changing the code setting or I replacing the battery. THERE ARE NO OTHER USER SERVICEABLE

PARTS. J

Your 53000SRT series garage door opener (with receiver "SRT" button) has been factory set to operate with the large push button on the remote control(s). However, you can use either of the two small buttons, if you prefer. And, the 3-function remote control(s) can also activate additional garage door openers and/or light controls.

Below are instructions for programming your opener to match the other buttons on your remote controls and any additional remote controls you may 3urchase. See available accessories on page 38.

53000SRT Series Garage Door Openers

(With "SRT" Button)

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the wall push button(s) or remote control(s).

A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted.

Mini 3-Function	Figure 1
Remote Control

Your "SRT" garage door opener will operate with as many as four "SRT" portable remote controls and one Multi-Function Keyless Entry.

To Add A Remote Control

1.Select a remote control push button to operate the receiver.

2.Press and hold the selected remote control push button, Figure 1.

3.Then press and release the "SRT" button on the right side panel of the opener in Figure 2. The opener light will flash once.

Now the opener will operate when the remote control push button is pressed.

If you release the remote control push button before the opener light flashes, the opener will not accept the code.

To Change the Selected Push Button

On the Same Remote control

If you decide to use a different remote control button than originally programmed into the opener, you must erase all the learned codes and reprogram each remote control used to operate the garage door opener.

To Erase All Remote control Codes

•Press and hold the "SRT" button on the opener panel until the indicator light turns off (about 6

seconds). AIIthe codes the opener has learned will be erased.

•To reprogram, repeat Steps 1,2 and 3 for each remote control in use.

Code programming instructions are also located on the opener panel.

Select a remote controt push button to operate opener

Standard 3-Function Remote Control

Garage Door Opener Figure 2 (With "Smart" Button)

© ©

"SRT" Indicator

Button Light

END PANEL

33