o

Touch Code Lock

NIodel 139.53716

n

KEYBOARD

CONSOLE

The Touch Code Lock consists of a keyboard and a console The keyboard sends a coded signal from outside the garage

The console fastens to an inside garage wall it receives the 4-digit programmed coded signal and _tarts the door opener

The Touch Code Lock will work with most Genie "Push Twice to Operate" openers if you press any other digit after

you enter the 4-digit programmed code°

NOTE: CABLE CONNECTOR HOLE IS LOCATED ON LEFT SIDE OF CONSOLE IF POSSIBLE,

SIDE OF GARAGE (DETERMINED BY FACING GARAGE FROM OUTSIDE) IF INSTALLED ON BE ROUTED OVER OR UNDER CONSOLE

INSTALL TOUCH CODE LOCK ON LEFT RIGHT SIDE OF GARAGE, CABLE MUST

FEATURES OF THE DIGITAL TOUCH CODE LOCK

Personalized Code: 10,000 possible combinations Code can be changed easily if desired

Operation: Opener activates when programmed code is entered on the keyboard

The user has 10 seconds from the time the first number is pressed to enter the 4-digit code

If incorrect numbers are accidentally pressed, a 5 second interval is necessary before starting over.

Power Supply: Operates from the garage door opener power with a battery b&ck-up for code memory and light- ed keyboard Unit wiU not operate without battery

Installation: Simple to install in 5 easy steps

Console: Provides an additional push button controt to operate door from inside garage

Keyboard; Thegarage door can be operated after a valid code entry by pressing ANY single key AS LONG AS THE KEYBOARD LIGHT REMAINS ON..

Keyboard Illuminates and remains lit for 10 seconds when ANY number is pressed in darkness this feature allows user to press ANY number before entering the 4-digit code

IMPORTANT NOTE: When illumination is needed, avoid pressing keyboard area which contains the first code number.

DISCONNECT THE POWER TO THE GARAGE DOOR OPENER BEFORE BEGINNING INSTALLATION.

STEP 1--SECTIONAL DOORS: Draw two intersecting lines on garage jamb face--horizontally at eye level and vertically

as close to centedine as possibfe Make sum there is at least 1-t/4" clearance on each side of the vertical line. Drill a

1" diameter hole through the jamb at marked location.

Refer to illustration on Side 2 if your garage has a built_

up jamb.

Keyboard

Optional

Location

STEP 1--ONE-PIECE DOORS: install the keyboard on the exterior front wal! of a FRAME garage Position it away from the door opening to avoid injury as door swings out and up Drill a 1" diameter hole through wall at eye level Refer to note below; then proceed to Step 2

Garage riot

Doer Jamb

Edge

 

 

 

 

PARTS LIST

 

Conso}e

Assembly

 

 

41D2940

Keyboard

Assembly

 

 

,HD2952

9

Volt Battery

 

 

 

10A13

2

Strand

Betl

Wire

, ,

,

219A276

Transformer Kit

(inc

bel!

wire)

41A3468

NOTE: If garage is Constructed of material other than

wood (brick, stone or aluminum siding), install keyboard

on door jamb with this important exception: LOCATE KEY-

BOARD ON OUTSIDE EDGE OF DOOR JAMB TO AVOID INJURY AS DOOR SWINGS OUT AND UP_

NO USER SERVICEABLE PARTS.

For repair, contact a SEARS Service Center

Side 1

Page 1
Image 1
Sears 139.53716 user service NIodel, Keyboard Console, Features of the Digital Touch Code Lock, Up jamb