Owner's Manual
Model 139.53879
To comply with FCC rules, adjustment or moditicalions o! 1his receiver end!or transmitter are prohibited except for changing the code seltlng or replacing the
battery THERE ARE NO OTHER USER SERVICEABLE PARTS
Model 139.53859
Compact
The 53000 Series remote control works only with door openers and light controls having a green "SRT" button and green indicator light.
Instructions are given below for programming your
opener to match the remote control's code. The additional remote control buttons can also activate
other garage door openers and/or light controls. (Instructions for programming light products are included with those accessories.)
operating or playing with a garage door
opener can injure themselves or others. The
garage door could close and cause serious Injury or death. Do not allow children to operate the
door push button(s) or remote control(s).
A moving garage door could Injure or kill someone under It. Activate the opener only when
you can see the door clearly, it is free of obstructions, and Is properly adjusted.
......I_L | i, | i,I | ' in |
Program the Opener to Accept the Remote Control Code
Select a remote control push button to operate the receiver The large button is recommended for use with the garage door opener.
1 Press and HOLD the selected remote control push button, Figure 1_
2.Then press and release the green "SRT" button on the right side panel of the opener in Figure 2oThe opener light wit flash once.
3 Retease the remote control push button
Now the opener wilt operate when the remote control push button is pressed
If you release the remote control push button before the opener light flashes, the opener has not accepted the code.
To Change the Selected Push Button
On the Same Remote Control
If you decide to use a different remote control button than originally programmed into the opener, you need to erase aflthe learned codes and reprogram each remote control used to operate the garage door opener
To Erase All Remote Control Codes
. Press and hold the green "SRT" button on the opener panel until the indicator light turns off (about 6
seconds). All the codes the opener has learned will be erased.
-To reprogram, repeat Steps I - 3 for each remote control in use,
Code programming instructions are also located on the opener panel.
3_Function remote control housing only (no circuit board) - 4 IA4873;
Compact remote controlReplacementhousing only (noParts:circuit board) - 4 IA4874; ] 3V 2016 Lithium Battery - 10A!9 (2 required); Visor Clip - 29£I 34
L
FIGURE 1 select e remote control push
button 1ooperate opener
Compact | ||
Remote Control | Remote | Control |
53000 Series Garage Door Openers
(With Green "SRT" Button and Green Indicator Light)
Green "SRT"
Button
Green Indicator
Ught
| The Remote | Control | Batteries |
| |
The lithium batteries should |
| ||||
produce | power for up to 5 | 'toh'_ve;dd | |||
Replace | batteries positive | side |
| cracking | |
.own,as,oliows |
|
|
|
| |
|
| Twlst _&') | |||
visor clip | or screwdriver | _,_ |
|
| |
|
| COMPACT |
|
|
blade to pry open the case
as shown To repIace the cover, insert the 3 tabs at the opposite end and snap shut
Compact remote Use a screwdriver b!ade to pry open the case as shown To replace cover, snap shut along both sides
| © 1995, Sears Roebuck & Company |
|
114A 1959 | All Rights Reserved | Pnnled in Mexico |