Sears 139.53930D owner manual Install the Door Control

INSTALLATION STEP 6

Install the Door Control

Locate door control within sight of door, at a minimum height of 5 feet (1.5 m) where small children cannot reach, away from moving parts of door and door hardware.

If installing into drywall, drill 5/32" holes and use the anchors provided. For pre-wired installations (as in new home construction), it may be mounted to a single gang box (Figure 2).

1 .Strip 7/16" (11 mm) of insulation from one end of bell wire and connect to the two screw terminals on back of

door control by color: white wire to 2 and white/red wire to the 1.

2.Remove cover by gently prying along one side with a screwdriver (Figure 1). Fasten with 6ABx1-1/4" self-tapping screws (drywall installation) or 6-32xl" machine screws (into gang box) as follows:

•Install bottom screw, allowing 1/8" (3 mm) to protrude above wall surface.

•Position bottom of door control on screw head and slide down to secure. Adjust screw for snug fit.

•Drill and install top screw with care to avoid cracking plastic housing. Do not overtighten.

•Insert top tabs and snap on cover.

3.(For standard installation only) Run bell wire up wall and across ceiling to motor unit. Use insulated staples to secure wire in several places. Do not pierce wire with a staple, creating a short or open circuit.

4.Strip 7/16" (11 mm) of insulation from end of bell wire. Connect bell wire to the quick-connect terminals as follows: white to white and white/red to red.

NOTE: When connecting multiple door controls to the opener, twist same color wires together. Insert wires into quick-connect holes: white to white and red/white to red.

5.Position the antenna wire as shown.

6.Use tacks or staples to permanently attach entrapment warning label to wall near door control, and manual release/safety reverse test label in a prominent location on inside of garage door.

NOTE: DO NOT connect power and operate opener at this time. The trolley will travel to the full open position but will not return to the close position

until the sensor beam is connected and properly aligned.

To prevent possible SERIOUSINJURYor DEATHfrom electrocution:

•Besure power is not connected BEFOREinstalling door control.

•Connect ONLYto 24 VOLTlow voltage wires.

To prevent possible SERIOUSINJURYor DEATHfrom a closing garage door:

•Install door control within sight of garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and away from all moving parts of door.

•NEVERpermit children to operate or play with door control push buttons or remote control transmitters.

•Activatedoor ONLYwhen it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.

•ALWAYSkeepgarage door in sight until completely closed. NEVERpermit anyone to cross path of closing garage door.

Outside Keylock Accessory Connections I To opener quick-connect terminals: white to white;

white/red to red.

			HARDWARE	SHOWN
			ACTUAL	SIZE
Door	Control Button
			Insulated
Control Console		(std installation)	Staples
Control Console		(pre-wired)	Drywall Anchors
Figure	I	Figure 2
REMOVE & REPLACE		COVER	PRE-WIRED
To Replace,			INSTALLATION
Insert		To Remove,
Top Tabs		Twist
First		Here
				24 Volt
				2-Conductor
				Bell Wire
Lighted		Quick-Connect

Push Butto__	2-ConductorllWire	Terminals
STANDARD
CONTROL	CONSOLE	STANDARD	CONTROL
		'BACK VIEW)
			Top
			Mounting
			Hole
			Terminal
			Screws
		Antenna	Bottom
		Bell	Mounting
		Wire	Hole

17