INSTALLATION STEP 1 1
Fasten the Door Bracket
Follow instructions which apply to your door type as illustrated below or on the following page.
A horizontal reinforcement brace should be long enough to be secured to two vertical supports. A vertical reinforcement brace should cover the height of the top panel.
The illustration shows one piece of angle iron as the horizontal brace. For the vertical brace, two pieces of angle iron are used to create a
door manufacturer for an opener installation door reinforcement kit.
NOTE: Many vertical brace installations provide for direct attachment of the clevis pin and door arm. In this case you will not need the door bracke# proceed to Installation
Step 12.
SECTIONAL DOORS
Fiberglass,aluminum or lightweight steel garage doors WILL REQUIREreinforcement BEFOREinstallation of door bracket.
Contactyour door manufacturerfor reinforcement kit.
HARDWARE SHOWN ACTUAL SIZE
© ©
Nut | LockWasher | 5/16" |
Carriage Bolt
•Center the door bracket on the previously marked vertical centerline used for the header bracket
installation. Note correct UP placement, as stamped inside the bracket (Figure 2).
•Position the bracket on the face of the door within the following limits:
A)The top edge of the bracket
B)The top edge of the bracket directly below any structural support across the top of the door.
•Mark and drill 5/16" left and right fastening holes.
Secure the bracket as shown in Figure 1 if there is vertical reinforcement.
If your installation doesn't require vertical reinforcement but does need top and bottom fastening holes for the door bracket, fasten as shown in Figure 2.
Header Bracket
Horizontal and vertical reinforcement
is needed for lightweight garage doors (fiberglass, aluminum, steel, doors with glass panel, etc.). (Not Provided)
| Vertical |
|
| Reinforcement |
|
|
| Vertical |
|
| Centerline |
|
| //of Garage |
|
| ,' Door |
| Carriage Bolt | UP |
|
| |
ge |
|
|
of Door or |
|
|
| Door |
|
einforcement Board | Bracket |
|
| Lock Washer | |
| 5/16" |
|
| Nut |
|
| z |
Figure 1
Door Bracket | Figure 2 |
23