Sears Comprehensive Programming Guide for Garage Door Opener Models

PROGRAMMING

NOTICE: If this Security.l_ garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The

owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical measure.

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional Security÷ ® remote controls.

To Add or Reprogram a Hand.held Remote Control

USING THE "LEARN" BUTTON

To Erase All Codes From Motor Unit

Memory

To deactivate any unwanted remote, first	_-_-L___®3i__
erase all codes:

Press and hold the "learn" button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous

codes are now erased. Reprogram each remote or keyless entry you wish to use.

1.Press and release the "learn" button on the motor unit. The learn

indicator light will glow steadily for 30 seconds.

2.Within 30 seconds, press and hold the button on the hand-held remote*

that you wish to operate your garage door.

3.Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

*3-Function Remotes

If provided with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any Security÷ ® 3-Function

remote or compact remote _._-'-_'_'_'_'_'_'_can be programmed to

operate other Security÷ ® garage door openers.

35