Sears EXAMPLE, ONE-PIECEDOOR WITHOUT TRACK, One-piecedoor without track: jamb hardware, One-piecedoor without track: pivot hardware

ONE-PIECE DOOR WITHOUT TRACK

1.Close the door and mark the inside vertical centerline of your garage door. Extend the line onto the header wall above door, as shown.

If headroom clearance is minimal, you can install the header bracket on the ceiling. See page 14.

If you need to install the header bracket on a 2x4 (on wall or ceiling), use lag screws (not provided) to securely fasten the 2x4 to structural supports as shown.

2.Open your door to the highest point of travel as shown. Measure the distance from the top of the door to the floor. Subtract the actual height of the door. Add 8" to the remainder. (See Example).

3.Close the door and draw an intersecting horizontal line on the header wall at the determined height.

NOTE: If the total number of inches exceeds the height available in your garage, use the maximum height possible, or refer to page 14 for ceiling installation.

Unfinished

Ceiling

	Structural
Header Wall	Supports
	Vertical
	Centerline
	2x4
	2x4
	OPTIONAL
	CEILING MOUNT
	FOR
	HEADER BRACKET

Vertical

Centerline

of Garage

Door

EXAMPLE
Distance from top of door
(at highest point of travel) to floor ......................	92"
Actual height of door ..........................................	-88"
Remainder..........................................................	4"
Add.....................................................................		+8"
Bracket height on header wall............................	=12"
(Measure UP from top of CLOSED door.)

Proceed to Step 2, page 14.

Header Wall

Highest Point

of Travel

Door
Jamb	Distance
Hardware

Floor

One-piece door without track: jamb hardware

Highest Point

of Travel

Header Wall

Door	Distance
	Pivot

Floor

One-piece door without track: pivot hardware

13