Lockout position (Manual disconnect)

Using the Wall-Mounted Door Control

Press the lighted push

 

Lighted

button to open or close the

 

Push Button

 

 

door. Press again to reverse

 

 

the door during the closing

 

Light

cycle or to stop the door

 

 

Button

while it's opening.

LIGHT

Lock

LOCK

 

 

Button

THE PREMIUM CONTROL CONSOLELight feature

Press the Light button to turn the opener light on or off. It will not control the opener light when the door is in motion. If you turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press again to turn it off sooner.

To Open the Door Manually

WARNING

•To prevent possible SERIOUS INJURY or DEATH from a falling garage door:

–If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.

–NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.

•NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.

Lock feature

Designed to prevent operation of the door from hand- held remote controls. However, the door will open and close from the Door Control, the Outdoor Key Switch and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2 seconds. The push button light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for 2 seconds. The push button light will stop flashing. The Lock feature will also turn off whenever the SRT (Smart Receiver/Transmitter) button on the motor unit panel is activated.

DISCONNECT THE TROLLEY:

The door should be fully closed if possible. Pull down on the emergency release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually. The lockout feature prevents the trolley from reconnecting automatically, and the door can be raised and lowered manually as often as necessary.

Trolley

Trolley Release arm (In Manual Disconnect Position)

NOTICE

Additional feature when used with the 3-function hand-held remote
TO RE-CONNECT THE TROLLEY:

To control the opener lights:

In addition to operating the door, you may program the remote to operate the lights.

1. With the door closed, press and

hold a small remote button that you want to control

the light.

2. Press and hold the Light button on the

door control.

Pull the emergency release handle toward the opener at a 45° degree angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either manually or by using the door control or remote.

Trolley

Emergency Release Handle (Pull at 45° angle)

Trolley

Release

Arm

NOTICE

3. While holding the Light button, press and hold the

Lock button on the door control.

4. After the opener lights flash, release all buttons.

To reconnect

32