Sears 14171 Care Of Surfaces, Care Of Air Gap, Preparation For Moving, Disconnect electricalpower

CARE OF SURFACES

'eancontrol panel with lightly ,ampened cloth. Dry thoroughly.

.DO NOT use abrasives or sharp objects--they cou!d damage the control panel.

•Clean outside cabinet finish with a good appliance p_lish wax. DO NOT use scouring pads, harsh or gritty cleaners.

•Interior is self-cleaning with normal use. If it should ever need cleaning, use a mild cleansing powder. If hard water causes lime build-up, clean as follows:

--Pour 2 cups white vinegar into empty dishwasher. DO NOT use detergent.

--Operate machine on NORMAL WASH cycle.

PROTECTION AGAINST

FREEZING

If dishwasher is left in an unheated place during the winter:

•Shut off water and electrical power.

•Remove access panel.

•Disconnect Water lines from valve. Drain into a flat pan.

•Drain collection chamber at rear of unit below filter by disconnecting hose to pump.

•Remove plastic pump cover in tub bottom and use sponge to soak up any remaining water.

•Reconnect water lines to valve and hoses to pump.

Pumpcoverscrews

CARE OF AIR GAP

If an air gap was installed for your built-in dishwasher, check to make sure it is

clean. Air gaps are usually mounted on the countertop and can be inspected by removing the cover. The air gap is not part of your dishwasher and is not covered by Sears warranty.

Drain air gap

PREPARATION FOR MOVING

•Disconnect electricalpower.

•Turn off watersupply,disconnectwater and drain lines.

•Tape racks in place; close door securely and tape it shut.

•Wrap with blankets and, if using a hand truck, lift dishwasher from side in upright position only.

13