Sears 16, 153, 514, 090 warranty SP I 1.5

LINE SPACE

÷G

Ill	!
SP I 1.5 2

			PITCH
		+
Ill	12	15	I
10
<>PITCH

=Set Typing Controls

1)Une Spacing

Hold down the Code Key and press the "1" Key. "_ LINE SP 1 1.5 2" appears on the LCD, The line space in use will blink.

To change the line spacing, hold down the Code Key and press the "1" Key again. The line spacing changes each -time the "1" Key is pressed, and the respective setting blinks.

Releasing the Code Key sets the line spacing and automatically terminates the selection mode.

Setting 2 provides double spacing (3 lines per inch), Setting 1-1/2 provides one-and-a-half spacing (4 lines per inch).

Setting 1 provides single spacing (6 lines per inch).

OUne space selection can be performed in the NP mode, and in the LP or JUST modes when there are no charac- ters on the LCD.

®Your typewriter has a memory back-up battery which pro- tects the line space/print pitch settings for a minimum of five years, even when the power switch is turned off.

@When power is turned on, six beeps sound if the back-up battery has been completely drained. The line space/print pitch settings are cleared.

Please contact your nearest Sears Service Center in this case.

/

2)Print Pitch

The print pitch should be set to match the Printwheel being used. Typing can be done with different pitches on the same line.

Hold down the Code Key and press the "2" Key.

"<_ PITCH 10 12 15" appears on the LCD and the pitch in use will blink.

To change the print pitch, hold down the Code Key and press the "2" Key again. The print pitch changes each time the "2" Key is pressed and the respective setting blinks.

Releasing the Code Key sets the print pitch and automat- ically terminates the selection mode.

10:	PICA pitch	_	10	characters	per	inch
12:	ELITE pitch	_	12	characters	per	inch

15:MICRO pitch _ 15 characters per inch

®Print pitch selection can be performed in the NP mode, and in the LP or JUST modes when there are no charac-

ters on the LCD.