4. HOW TO CHANGE:OORRECTIONTAPETakeup Spindle Supply Spindle
It
1)
2)
Removing Correction Tape
Turn off the machine. Open the Top Cover and remove
the Ribbon Cassette as explairied under "Removing Rib-
bon Cassette".
Remove the left and right spools from the respective spin-
dles. Be sure notto pull on the spindle hub when remov-
ing the right spool.
Tape Guides 3) Grasp both spools and bring back to a position that is
parallel with the Tape Guides. Pull on the Correction Tape
to take up any slack and lift it out of thetypewriter.
Card Holder
Print'wheel
1
1)
Installing Correction Tape
While holding the two spools in your hands, unwind the
Correction Tape and position behind the Tape Guides and
Printwheel as shown. Make sure that the sticky side of
the tape faces the Card Holder.
Takeup Spindle Supply Spindle 2) Fit the full spool of the Correction Tape onto the Right
(Supply) Spindle. Then fit the left spool (the one with the
knob) onto the Left (Takeup) Spindle.
3)
®
Turn the leftspool counterclockwise until the colored por-
tion of the tape disappears.
Check again to make sure that the Correction Tape has
been fed properly behind the leftand right Tape Guides.
4) Replace the Ribbon Cassette and close the Top Cover.