Sears 172.103 Operation AS a Screwdriver Fig, General Maintenance, ON-TOOL BIT Storage Fig

OPERATION cont.

OPERATION AS A SCREWDRIVER (Fig. 15)

Turn and set the torque clutch collar to the desired torque setting, 1 through 15. Install and tighten the desired fastener accessory bit into the chuck.

1.	Install the battery pack into the drill/driver.
2.	Push the forward/reverse selector switch
	to the forward position.
3.	Follow the guidelines on page 19 to arrive
	at the proper torque setting for your job.
4.	Make a few practice runs, driving screws in
	scrap material, to make sure you have the
	clutch set at the proper torque setting for

Fig. 15

Companion

MAINTENANCE

!WARNING: To avoid serious personal injury, always remove the battery pack from the tool when cleaning or performing any maintenance.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil and grease, etc.

!WARNING: Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.

	your job.
5.	When all adjustments are correct, drive
	and tighten your fasteners.
6.	To remove fasteners, push forward/reverse
	selector switch to the reverse position.

ON-TOOL BIT STORAGE (Fig. 16)

Your drill/driver comes with 2 double-ended screwdriver bits, 1 phillips and

1 slotted / square drive. When not in use, these bits can be stored on the base

Fig. 16

CHUCK REMOVAL (Figs. 17, 17a and 17b)

The chuck may be removed and replaced by a new one.

1.Lock the trigger switch by placing the Forward / Reverse Selector Switch with Power Lock-Off in center, or OFF position.

2.Insert a 5/16-in. or larger hex key into the jaws of the chuck of the drill and Tighten the chuck jaws securely.

3.Tap the hex key sharply with a mallet in a clockwise direction (see Fig. 17). This will loosen the screw in the chuck for easy removal.

4.Open the chuck jaws and remove the hex key. Using a Phillips screwdriver, remove the chuck screw by turning it in a clockwise direction (see Fig. 17a).

NOTE: The chuck screw has left hand threads.

Fig. 17a

Fig. 17

9

7

5 Companion

3

1

9

7

5 Companion

3 1

MAINTENANCE

!WARNING: When servicing, use only identical Sears replacement parts. Use of any other part may create a hazard or cause product damage.

!WARNING: ALWAYS wear safety goggles or safety glasses with side shields when using compressed air to clean tools. If the operation is dusty, also wear a dust mask.

5.Insert the hex key back into the chuck and tighten the chuck jaws securely. Tap sharply with a mallet in a counterclockwise direction (see Fig. 17b). This will loosen the chuck on the spindle. It can now be unscrewed by hand.

Fig. 17b

9

7

5 Companion

3 1

22

23

10-4-07 Drill

10300-10400